Configure Dhcpv4 Global Relay Port - ZyXEL Communications XMG1930 Series User Manual

Figure 199 IP Application > DHCP > DHCPv4 > Global
The following table describes the labels in this screen.
Table 147 IP Application > DHCP > DHCPv4 > Global
LABEL
Active
Remote DHCP
Server 1 .. 3
Option 82 Profile
Apply
Cancel

35.4.4 Configure DHCPv4 Global Relay Port

Use this screen to apply a different DHCP option 82 profile to certain ports on the Switch. To open this
screen, click IP Application > DHCP > DHCPv4 > Global > Port.
Figure 200 IP Application > DHCP > DHCPv4 > Global > Port
Chapter 35 DHCP
DESCRIPTION
Select this check box to enable DHCPv4 relay.
Enter the IP address of a DHCPv4 server in dotted decimal notation.
Select a pre-defined DHCPv4 option 82 profile that the Switch applies to all ports. The Switch
adds the Circuit ID sub-option and/or Remote ID sub-option specified in the profile to DHCP
requests that it relays to a DHCP server.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XMG1930 Series User's Guide
289