ZyXEL Communications XMG1930 Series User Manual page 119

Figure 84 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Setup
The following table describes the labels in this screen.
Table 48 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Setup
LABEL DESCRIPTION
Interface Type Select the type of IPv6 interface for which you want to configure. The Switch supports the VLAN
interface type for IPv6 at the time of writing.
Interface ID Specify a unique identification number (from 1 to 4094) for the interface.
A static IPv6 neighbor entry displays in the Management > IPv6 Neighbor Table screen only when
the interface ID is also created in the Basic Setup > Interface Setup screen.
To have IPv6 function properly, you should configure a static VLAN with the same ID number in the
Advanced Application > VLAN screens.
Neighbor Specify the IPv6 address of the neighboring device which can be reached through the interface.
Address
MAC Specify the MAC address of the neighboring device which can be reached through the
interface.
Add Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Clear Click Clear to reset the fields to the factory defaults.
Index This is the interface index number. Click an index number to change the settings.
Interface This is the name of the IPv6 interface you created.
Neighbor This field displays the IPv6 address of the neighboring device which can be reached through the
Address interface.
MAC This field displays the MAC address of the neighboring device which can be reached through the
interface.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the table
heading row to select all entries.
Delete Check the entries that you want to remove and then click Delete to remove the selected entries
from the summary table.
Cancel Click Cancel to clear the check boxes.
Chapter 8 Basic Setting
XMG1930 Series User's Guide
119