ZyXEL Communications XMG1930 Series User Manual page 283

The following table describes the related labels you use to create a static route.
Table 140 IP Application > Static Routing > IPv6 Static Route
LABEL DESCRIPTION
Route Enter the IPv6 address of the final destination.
Destination
Prefix Length Enter the prefix length number of up to 64 for this destination.
Next Hop Enter the IPv6 address of the next-hop router.
Interface Type Select the type of the IPv6 interface through which the IPv6 packets are forwarded.
The Switch supports only the VLAN interface type at the time of writing.
Interface ID Enter the ID number of the IPv6 interface through which the IPv6 packets are forwarded.
Add Click Add to insert a new static route to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Index This field displays the index number of the route. Click a number to edit the static route entry.
Interface This field displays the descriptive name of the interface that is used to forward the packets to
the destination.
Route This field displays the IPv6 subnet prefix and prefix length of the final destination.
Destination/Prefix
Length
Next Hop This field displays the IPv6 address of the gateway that helps forward the packet to the
destination.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Click Delete to remove the selected entry from the summary table.
Cancel Click Cancel to clear the check boxes.
Chapter 34 Static Route
XMG1930 Series User's Guide
283