Activate Mac Authentication - ZyXEL Communications XMG1930 Series User Manual

Table 80 Advanced Application > Port Authentication > 802.1x (continued)
LABEL
Reauth
Reauth-period
secs
Quiet-period secs
Tx-period secs
Supp-Timeout
secs
Apply
Cancel

18.4 Activate MAC Authentication

Use this screen to activate MAC authentication. In the Port Authentication screen click MAC
Authentication to display the configuration screen as shown.
Figure 129 Advanced Application > Port Authentication > MAC Authentication
Chapter 18 Port Authentication
DESCRIPTION
Specify if a subscriber has to periodically re-enter his or her user name and password to stay
connected to the port.
Specify the length of time required to pass before a client has to re-enter his or her user name
and password to stay connected to the port.
Specify the number of seconds the port remains in the HELD state and rejects further
authentication requests from the connected client after a failed authentication exchange.
Specify the number of seconds the Switch waits for client's response before re-sending an
identity request to the client.
Specify the number of seconds the Switch waits for client's response to a challenge request
before sending another request.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XMG1930 Series User's Guide
180