Network Proxy Configuration - ZyXEL Communications XS3800-28 User Manual

28-port 10gbe l3 managed switch

Hide thumbs Also See for XS3800-28:

Table of Contents

Table 32 Basic Setting > IP Setup > IP Configuration (continued)

IP Subnet Mask

8.6.5 Network Proxy Configuration

The proxy server of an organization may prohibit communication between the Switch and NCC (Nebula

Control Center)

Switch and NCC through the proxy server.

Figure 82 Network Proxy Configuration Application

As of this writing, this setting only allows communication between the Switch and the NCC.

Figure 83 Basic Setting > IP Setup > IP Configuration > Network Proxy Configuration

Chapter 8 Basic Setting

Click this to create a new entry.

This saves your changes to the Switch's run-time memory. The Switch loses these changes if it is

turned off or loses power, so use the Save link on the top navigation panel to save your changes

to the non-volatile memory when you are done configuring.

Click Cancel to reset the fields to your previous configuration.

This field displays the index number of an entry.

This field displays the IP address of the Switch in the IP domain.

This field displays the subnet mask of the Switch in the IP domain.

This field displays the VLAN identification number of the IP domain on the Switch.

This field displays the type of IP address status.

Select an entry's check box to select a specific entry. Otherwise, select the check box in the

table heading row to select all entries.

Click Delete to remove the selected entry from the summary table.

Note: Deleting all IP subnets locks you out of the Switch.

Click Cancel to clear the check boxes.

(Section 8.12 on page

142). Use this screen to enable communication between the

XS3800-28 User's Guide