Table of Contents
Advertisement
Figure 260 Management > Configure Clone
The following table describes the labels in this screen.
Table 189 Management > Configure Clone
LABEL
DESCRIPTION
Source/
Enter the source port under the Source label. This port's attributes are copied.
Destination
Enter the destination port or ports under the Destination label. These are the ports which are going
Port
to have the same attributes as the source port. You can enter individual ports separated by a
comma or a range of ports by using a dash.
Example:
2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.
2–6 indicates that ports 2 through 6 are the destination ports.
*
Select * to apply all settings to the port. Use this first to select the common settings and then
remove the settings you do not want copied.
Basic Setting
Select which port settings (you configured in the Basic Setting menus) should be copied to the
destination ports.
Advanced
Select which port settings (you configured in the Advanced Application menus) should be copied
Application
to the destination ports.
Chapter 48 Configure Clone
XMG1930 Series User's Guide
361
Advertisement
Table of Contents
Troubleshooting
