Pppoe Ia Per-Port Per-Vlan - ZyXEL Communications XMG1930 Series User Manual

Table 116 Advanced Application > PPPoE > Intermediate Agent > Port (continued)
LABEL
Server Trusted
State
Circuit-id
Remote-id
Apply
Cancel

29.3.2 PPPoE IA Per-Port Per-VLAN

Use this screen to configure PPPoE IA settings that apply to a specific VLAN on a port.
Click the VLAN link in the Intermediate Agent > Port screen to display the screen as shown.
Figure 168 Advanced Application > PPPoE > Intermediate Agent > Port > VLAN
Chapter 29 PPPoE
DESCRIPTION
Select whether this port is a trusted port (Trusted) or an untrusted port (Untrusted).
Trusted ports are uplink ports connected to PPPoE servers.
If a PADO (PPPoE Active Discovery Offer), PADS (PPPoE Active Discovery Session-confirmation),
or PADT (PPPoE Active Discovery Terminate) packet is sent from a PPPoE server and received on
a trusted port, the Switch forwards it to all other ports.
If a PADI or PADR packet is sent from a PPPoE client but received on a trusted port, the Switch
forwards it to other trusted ports.
Untrusted ports are downlink ports connected to subscribers.
If a PADI, PADR, or PADT packet is sent from a PPPoE client and received on an untrusted port,
the Switch adds a vendor-specific tag to the packet and then forwards it to the trusted ports.
The Switch discards PADO and PADS packets which are sent from a PPPoE server but received
on an untrusted port.
Enter a string of up to 63 single-byte printable characters that the Switch adds into the Agent
Circuit ID sub-option for PPPoE discovery packets received on this port. Spaces are allowed.
The Circuit ID you configure for a specific VLAN on a port (in the Advanced Application > PPPoE
> Intermediate Agent > Port > VLAN screen) has the highest priority.
Enter a string of up to 63 single-byte printable characters that the Switch adds into the Agent
Remote ID sub-option for PPPoE discovery packets received on this port. Spaces are allowed.
If you do not specify a string here or in the Remote-id field for a VLAN on a port, the Switch
automatically uses the PPPoE client's MAC address.
The Remote ID you configure for a specific VLAN on a port (in the Advanced Application >
PPPoE > Intermediate Agent > Port > VLAN screen) has the highest priority.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XMG1930 Series User's Guide
244