ZyXEL Communications XMG1930 Series User Manual page 219

Note: Refer to the documentation that comes with your RADIUS server on how to configure
VSAs for users authenticating through the RADIUS server.
The following table describes the VSAs supported on the Switch.
Table 101 Supported VSAs
FUNCTION
Ingress Bandwidth
Assignment
Egress Bandwidth
Assignment
Privilege Assignment
25.5.1.1 Tunnel Protocol Attribute
You can configure tunnel protocol attributes on the RADIUS server (refer to your RADIUS server
documentation) to assign a port on the Switch to a VLAN based on IEEE 802.1x authentication. The port
VLAN settings are fixed and untagged. This will also set the port's VID. The following table describes the
values you need to configure. Note that the bolded values in the table are fixed values as defined in
RFC 3580.
Table 102 Supported Tunnel Protocol Attribute
FUNCTION
VLAN Assignment
Chapter 25 AAA
ATTRIBUTE
Vendor-Id = 890
Vendor-Type = 1
ingress rate (Kbps in decimal format)
Vendor-data =
Vendor-Id = 890
Vendor-Type = 2
egress rate (Kbps in decimal format)
Vendor-data =
Vendor-ID = 890
Vendor-Type = 3
Vendor-Data = "shell:priv-lvl=N"
or
(CISCO)
Vendor-ID = 9
(CISCO-AVPAIR)
Vendor-Type = 1
Vendor-Data = "shell:priv-lvl=N"
where is a privilege level (from 0 to 14).
N
Note: If you set the privilege level of a login account differently on the RADIUS
servers and the Switch, the user is assigned a privilege level from the
database (RADIUS or local) the Switch uses first for user authentication.
ATTRIBUTE
Tunnel-Type = VLAN(13)
Tunnel-Medium-Type = 802(6)
Tunnel-Private-Group-ID =
Note: You must also create a VLAN with the specified VID on the Switch.
Note: The bolded values in this table are fixed values as defined in RFC 3580.
XMG1930 Series User's Guide
219
VLAN ID