35.4.1.2 Sub-Option Format
There are two types of sub-option: "Agent Circuit ID Sub-option" and "Agent Remote ID Sub-option".
They have the following formats.
Table 144 DHCP Relay Agent Circuit ID Sub-option Format
SubOpt Code
1
(1 byte)
Table 145 DHCP Relay Agent Remote ID Sub-option Format
SubOpt Code
2
(1 byte)
The 1 in the first field identifies this as an Agent Circuit ID sub-option and two identifies this as an Agent
Remote ID sub-option. The next field specifies the length of the field.
35.4.2 DHCPv4 Option 82 Profile
Use this screen to create DHCPv4 option 82 profiles. Click IP Application > DHCP > DHCPv4 in the
navigation panel and click the Option 82 Profile link to display the screen as shown.
Figure 198 IP Application > DHCP > DHCPv4 > Option 82 Profile
Note: The string of any field in this screen should not contain [ ? ], [ | ], [ ' ], [ " ] or [ , ].
The following table describes the labels in this screen.
Table 146 IP Application > DHCP > DHCPv4 > Option 82 Profile
LABEL
Name
Circuit-ID
Chapter 35 DHCP
Length
N
Slot ID, Port ID, VLAN ID, System Name or String
(1 byte)
Length
N
MAC Address or String
(1 byte)
DESCRIPTION
Enter a descriptive name for the profile for identification purposes. You can use up to 32 single-
byte printable characters.
Use this section to configure the Circuit ID sub-option to include information that is specific to
the relay agent (the Switch).
XMG1930 Series User's Guide
Value
Value
287