Cmd_Uartdisable_Req - We PROTEUS-III User Manual

WIRELESS CONNECTIVITY & SENSORS
User manual Proteus-III
Response ( CMD_FACTORYRESET_CNF ):
Start signal
0x02
Status:
0x00: Request received, will perform factory reset now
0x01: Operation failed
0xFF: Operation not permitted
To save the parameters in the flash memory of the module, the particular mem-
ory segment must first be flushed entirely and then restored from RAM. If a
reset occurs during this procedure (e.g. due to supply voltage fluctuations), the
entire memory area may be destroyed.
During start-up of the device, the user settings memory is checked for consis-
tency. In case of inconsistency (e.g. the memory was erased) the device will
perform a factory reset.
This command also removes all bonding data.

7.5.6. CMD_UARTDISABLE_REQ

This command disables the UART of the module. It will be re-enabled when the module has to
send data to the host (e.g. data was received via RF or a state is indicated) or if the WAKE_UP
pin is used (apply a falling edge, hold low for at least 10ms before applying a rising edge
and hold high for at least 10ms). In this case, either the received data or a CMD_UARTENABLE_
IND is transmitted by the module. Afterwards the UART will stay active until another CMD_
UARTDISABLE_REQ or CMD_SLEEP_REQ or a timer triggered sleep event occurs.
Format:
Response ( CMD_UARTDISABLE_CNF ):
Order code 2611011024000
Version 1.8 , July 2022
Start signal Command
0x02 0x1C
Command | 0x40
0x5C
Start signal Command
0x02 0x1B
Length CS
0x00 0x00 0x1E
Length Status
0x01 0x00 1 Byte
Length CS
0x00 0x00 0x19
www.we-online.com/wcs
CS
1 Byte
87