Rf_Advertisingflags: Configure The Advertising Packet; Example 1; Advertising Packet Configuration Flags - We PROTEUS-III User Manual

WIRELESS CONNECTIVITY & SENSORS
User manual Proteus-III
8.13. RF_AdvertisingFlags: Configure the advertising packet
Settings
Designation
index
RF_AdvertisingFlags
29
The user setting RF_AdvertisingFlags specifies the content of the advertising packet.
Bit no.
Description
Define the content of the advertising packet
0x0
0x1
1 : 0
0x2
Others
7 : 2
Reserved.

8.13.1. Example 1

Set the advertising flags to 1 such that command mode and peripheral only mode use the same
advertising packet content using the CMD_SET_REQ with settings index 29
Start signal
0x02
Response CMD_SET_CNF : Successfully modified the setting.
Start signal
0x02
Order code 2611011024000
Version 1.8 , July 2022
Permissible
values
0,1,2
Command mode: Advertising packet contains 5 bytes device
name RF_DeviceName and the TX power and the UUID.
Peripheral only mode: Advertising packet contains 8 bytes
device name generated by the FS_BTMAC (A-123456 in case the
FS_BTMAC is 0x0018DA123456) and the UUID.
Advertising packet contains 8 bytes device name RF_DeviceName
and the UUID.
Advertising packet contains 26 bytes device name
RF_DeviceName and the TX power (only in case it matches due
to a short device name). The UUID is part of the scan response
packet, that can be only received by an active scan (see user
settings RF_ScanFlags ).
Using this option, the transmission of beacons is not more
supported.
Reserved.
Table 74: Advertising packet configuration flags
Command Length
0x11 0x02 0x00
Command | 0x40
0x51
Default value Permissions
0 read/write
Settings index Parameter
0x1D 0x01
Length Status
0x01 0x00 0x00
www.we-online.com/wcs
Number of
Bytes
1
CS
0x0D
CS
0x52
139