Quickstart Example - We PROTEUS-III User Manual

WIRELESS CONNECTIVITY & SENSORS
User manual Proteus-III

4.4. Quickstart example

This section describes how to quick start the data transmission between two Proteus-III mod-
ules. The goal is to setup a Bluetooth
transmit some data and close the connection again.
The below commands are in hexadecimal notation. The arrow in the left column
describes, whether it's a message from host to radio module, or vice versa.
A request command is always sent from host to module ( ). An indication,
confirmation or response message is always sent from module to host ( ).
For quick testing, a pair of Proteus-III-EV is recommended.
Connect the two devices (modules, EV-boards or USB dongles) to a PC. A terminal program, for
example hterm, is used to perform the communication via COM ports. The two corresponding
COM ports have to be selected and opened with a default configuration of 115200 Baud, 8
data Bits, 1 stop Bit and parity set to none (8n1).
To reproduce the following sequence, note that the MAC address FS_BTMAC
of every module is different. Thus it has to be replaced in the example com-
mands below. In addition, the checksum has to be adjusted, when adapting
any command. The command structure and checksum calculation is described
in chapter 7 .
Order code 2611011024000
Version 1.8 , July 2022
®
LE connection between module A and module B,
www.we-online.com/wcs
31