Cmd_Gpio_Remote_Writeconfig_Ind; Example: Two Gpios Have Been Configured By The Connected Remote Device To Output High - We PROTEUS-III User Manual

WIRELESS CONNECTIVITY & SENSORS
User manual Proteus-III

7.7.9. CMD_GPIO_REMOTE_WRITECONFIG_IND

This command indicates that the remote device has written the free GPIOs of the radio module.
Please note that only the GPIOs are part of this message, that have been
configured successfully. Failed attempts of GPIO configurations will not be
indicated by this message.
Format:
Start signal
0x02
The Block structure is as defined in CMD_GPIO_REMOTE_WRITECONFIG_REQ block structure .
7.7.9.1. Example: Two GPIOs have been configured by the connected remote device to
output high
Start signal Command
0x02 0xA8
The two GPIOs with ID 0x01 and 0x02 have been configured by the connected remote device
to output high.
Order code 2611011024000
Version 1.8 , July 2022
Command Length
0xA8 2 Bytes
Length
0x08 0x00 0x03 0x01 0x02 0x01
Block . . . Block
1
x Bytes x Bytes
Block
1
0x03 0x02 0x02 0x01
www.we-online.com/wcs
CS
n
1 Byte
Block CS
2
A1
113