Cfg_Flags: Configure The Module; Example 1; Example 2 - We PROTEUS-III User Manual

WIRELESS CONNECTIVITY & SENSORS
User manual Proteus-III
8.24. CFG_Flags: Configure the module
Settings
Designation
index
CFG_Flags
28
The user setting CFG_Flags specifies various module features.
Bit no.
Name
0
High throughput mode
Long range connection
1
mode
2
GPIO remote config.
Disconnect on
4
mismatch
Others
Reserved
The high throughput mode and its usage is described in the corresponding
Proteus-III application note.

8.24.1. Example 1

Enable the high throughput mode using CMD_SET_REQ with settings index 28
Start signal
0x02
Response CMD_SET_CNF : Successfully modified the setting.
Start signal
0x02

8.24.2. Example 2

Request the CFG_Flags using CMD_GET_REQ :
Order code 2611011024000
Version 1.8 , July 2022
Permissible
values
See
description
Description
Set this Bit to 1 to enable the high throughput mode.
Set this Bit to 1 to enable the mode using the LE Coded
mode during connection setup.
Set this Bit to 1 to block the GPIO configuration via
remote device.
Set this Bit to 1 to disconnect in case the central device
does not respect the peripheral's connection interval.
Do not modify.
Command Length
0x11 0x03 0x00
Command | 0x40
0x51
Default value Permissions
0 read/write
Settings index Parameter
0x1C 0x01 0x00
Length Status
0x01 0x00 0x00
Number of
Bytes
2
CS
0x0D
CS
0x52
157
www.we-online.com/wcs