Selecting Protocol (Emulate); Bidirectional Printing (Bidir) - Tally Dascom LA2810 User Manual

User Guide

Selecting Protocol (Emulate)

Selects the emulation for the USB or Ethernet Interface. When a printer
understands the control set written for another printer type, it is said to emulate
the other printer.
MTPL is also active in IBM or Epson emulation mode.
ESCChar Protocol
Back Next
1 2 3
Epson LQ-2550
Set < > Exit
1 2 3
If the printer is switched to online mode after changing the emulation, it performs a
reset.
Confirm the setting by pressing the Set key (1). Press the Next key (4) to access
the next group of parameters.
Bidirectional printing (PrinDir)
Setting On: Printer prints in both directions (bidirectional). Setting Off: Printer
prints only in one direction (from left to right).
Prindir I/O
Back Next
1 2 3
Prindir=Bidir
Set < > Exit
1 2 3
Confirm the setting by pressing the Set key (1).
The setting On will not be overwritten by ESC sequences.
Press Protocol (3) key. After pressing, select, by pressing te
Online
key under the proper communication port. First to display will
be Parallel Serial but if you press key #4, Next, USB Eth
4
(Ethernet) will display.
Setup
Afgter selecting your I/O port, use the < (2) or > (3) key to
*
select the desired emulation.
Online
Setting Options: Epson ESC PS/2, IBM XL24, DEC PPL2
4
Default Setting: EPS/2 for Parallel, DEC PPL2 for Serial,
Setup
Epson ESC PS/2 for USB, DEC PPL2 for Ethernet
Press PrinDir (2)
key.
Online
4
Setup
Use the < (2) or > (3) key to select the desired setting.
*
Online
Setting Options: Bidir/Unidir
4 Default Setting: Bidir
Setup
The menu
47