Setting The Tear Position - Tally Dascom LA2810 User Manual

Settings

Setting the tear position

If the tear position of the paper is not aligned with the tear edge of the printer, you can
adjust it. Inserted paper needs to be torn off if necessary and retracted to park position.
Adjust Paperway
Menu Char
1 2 3
TOF
Head Tear
1 2 3
TearAdj= 00/72"*
Set < > Exit
1 2 3
The correction made – a maximum of approx. 1" (2.5 cm) in each direction – will be
retained after switching the printer off.
It can be set separately for each paper path.
Make sure that the set form length corresponds to the actual length of the forms
you are using.
34
Online
Press the Setup key. The printer changes to setup mode.
4
Setup
Press the Adjust (2) key.
Online
Press the Tear (4) key.
4
Setup
Online
Press the < (2) or > (3) key to move the perforation to the
4
desired position. Confirm the input by pressing the Set (1) key.
Setup
Confirm the input again by pressing the Setup key. The printer is
reset to the initial status.
User Guide