Tally Dascom LA2810 User Manual page 116

User Guide
Message
Hardware Alarm
Parity Error
Frame Error
Overrun Error
Paperwidth Error
Press Online
Head Hot
Possible cause
Internal hardware error.
Transmission error from
computer to printer via the
optional serial interface.
Transmission error (serial
interface).
Received data which has
not yet been printed is
overwritten with new data.
A print job exceeds the
paper width with the
automatic paper width
detection active.
The printer prints at lower
speed.
Corrective action
▸Try switching off and on.
▸Check if changes to options have
been previously carried out.
▸Note down the display message.
Contact your dealer.
▸Compare the interface configuration
of your printer with the settings of
your computer (protocol), see
Interfaces.
▸Check the cable, if necessary
replace it.
▸The cable exceeds the maximum
allowed length, see
specifications.
▸Compare the format setting of your
printer with the setting of your
computer.
▸Check the permissible cable length,
see Interface specifications.
▸See parity error.
▸If an optional serial interface is
installed: Check that the correct
busy protocol (e.g. XON XOFF) is
set in the menu Serial interface,
protocol, see Protocol
▸Check the interface cable, see
section Connecting the
Interfaces.
▸Cancel the print job or load suitable
paper, see also Automatic paper
width detection (APW).
▸Try shifting the paper slightly to the
right.
▸Try shifting the paper slightly to the
left.
▸Check if the setted paper width in
your driver and application.
If this message appears although the
loaded paper is wide enough, please
contact your technical service.
▸No action required.
When this message comes up even in
a "cold" printer, please contact your
Troubleshooting
Interface
(Protocol).
printer, and
109