Setting The First Printing Line (Tof) - Tally Dascom LA2810 User Manual

User Guide

Setting the first printing line (TOF)

You can use the TOF function for setting the position of the first printing line for each paper source and
each menu individually.
Before using the TOF function, you should first set the tear position; see
Setting the tear
Adjust Paperway
Menu Char
1 2 3
TOF
Head Tear
1 2 3
B
A
FormAdj= 12/72"*
Set < > Exit
1 2 3
Confirm the setting by pressing the Set key (1).
Press the Next key (4) to access the next group of parameters.
The selection made will be retained after switching off the printer. If the Paper is
already loaded into the Printer and a change to the Form Adjust is made, the Paper
will need to e "Parked and Reloaded".
position.
Online
Press the Setup key. The printer changes to setup mode.
Press the Adjust (2) key.
4
Setup
Online
Press the TOF (3) key.
4
Setup
Online
Press the < (2) or > (3) key to move the first printing line to the
4
desired position.
Setup
You can set values from 0 to 220/72" for fanfold paper.
The paper is fed to the position where the
bottom edge of the first printing line A is
aligned with the tear edge B of the printer.
The factory setting for the first printing
position (TOF) is 12/ 72" (4,23 mm/1/6
inch). This is equivalent to the second line
from the top.
Settings
35