Selecting Character Density And Font - Tally Dascom LA2810 User Manual

Settings

Selecting character density and font

You can use the CPI (Character Per Inch) key in setup mode to select the number of
characters per inch to be printed. You can use the Font key to select resident fonts.
Adjust Paperway
Menu Char
1 2 3
Font CPI
1 2 3
10 CPI
Set < > Exit
1 2 3
ROMAN NLQ
Set < > Exit
1 2 3
Adjust Paperway
Menu Char
1 2 3
The selection made will not be retained after switching off the printer. For more details
on how to set the character density and fonts permanently, please refer to the chapter
Setting character density (CPI)
36
Online
Press the Setup key, then the Char (4) key.
4
Setup
Online
Press the CPI (4) or Font (1) key (in our example, press CPI).
4
Setup
*
Online
Use the < (2) or > (3) key to set the desired character
4
density. Confirm the selection by pressing the Set (1) key.
Setup
You can cancel the selection and leave the setting unchanged by
pressing the Exit (4) key.
Online
If you pressed the Font (1) key, use the < (2) or > (3) key to
4
select the desired font. Confirm the selection by pressing the
Setup
Set (1) key.
You can cancel the selection and leave the setting unchanged by
pressing the Exit (4) key.
Online
Press the Setup key. The printer returns to the initial status.
4
Setup
It is also possible to press the Online key. The printer then
changes directly to online mode.
and Selecting font (Font).
User Guide