Setting The First Printing Line (Tof) - Tally Dascom 2810 User Manual

User Guide

Setting the first printing line (TOF)

You can use the TOF function for setting the position of the first printing line for
each paper source and each menu individually.
Before using the TOF function, you should first set the tear position; see
Setting the tear position.
The selection made will be retained after switching off the printer.
Press the Setup key. The printer changes to setup mode.
Press the Adjust (2) key.
Press the TOF (3) key.
Press the < (2) or > (3) key to move the first printing line to
the desired position. You can set values from 0 to 220/72"
for fanfold paper.
Confirm the input by pressing the Set (1) key. Press the
Setup key. The printer returns to the initial status.
Options and accessories
The paper is fed to the position where
the bottom edge of the first printing
line A is aligned with the tear edge B
of the printer. The factory setting for
the first printing position (TOF) is 12/
72" (4,23 mm/1/6 inch). This is
equivalent to the second line from the
top.
41