Application Parameters By Industry - Delta C2000 Plus Series User Manual

13 Application Parameters by Industry

Industry-Specific Parameter Application
13-00
Settings
 NOTE: after you select the macro, some of the default values adjust automatically according to
the application selection.
 Group setting 02: Compressor (IM)
The following table lists the relevant compressor application parameters.
Pr.
00-11 Speed Control Mode
00-16 Duty Selection
00-17 Carrier Frequency
Master Frequency Command Source
00-20 (AUTO) / Source Selection of the PID
Target
00-21 Operation Command Source (AUTO)
00-22 Stop Method
00-23 Control of Motor Direction
01-00 Maximum Operation Frequency
01-01 Motor 1 Rated / Base Frequency
01-02 Motor 1 Rated / Base Output Voltage
01-03 Motor 1 Mid-Point Frequency 1
01-04 Motor 1 Mid-Point Voltage 1
01-05 Motor 1 Mid-Point Frequency 2
01-06 Motor 1 Mid-Point Voltage 2
01-07 Motor 1 Minimum Output Frequency
01-08 Motor 1 Minimum Output Voltage
01-11 Output Frequency Lower Limit
01-12 Acceleration Time 1
01-13 Deceleration Time 1
03-00 Analog Input Selection (AVI)
03-01 Analog Input Selection (ACI)
05-01 Full-Load Current For Induction Motor 1 (A)
05-03 Rated Speed for Induction Motor 1 (Rpm)
05-04 Number of Poles for Induction Motor 1
0: Disabled
1: User-defined Parameter
2: Compressor (IM)
3: Fan
4: Pump
10: Air Handling Unit, AHU
Explanation
Chapter 12 Descriptions of Parameter SettingsC2000 Plus
(appied to 230V / 460V models)
 You can set this parameter during operation
Default: 0
0 (V/F control)
0 (Normal load)
Default setting
2 (External analog input)
1 (External terminals)
0 (Ramp to stop)
1 (Disable reverse)
Default setting
Default setting
Default setting
Default setting
Default setting
Default setting
Default setting
Default setting
Default setting
20 (Hz)
20 (s)
20 (s)
0 (No function)
1 (Frequency command)
Default setting
Default setting
Default setting
12.1-13-1
Settings