Chapter 12 Description of Parameter SettingsCP2000
13 Application Parameters by Industry
Application Selection
Settings
After you select the macro, some of the default values adjust automatically according to the
application selection.
Each setting varies with different application selection, and its value is different as well.
Refer to Section 10-2 for more operation details.
Group settings: 2: Compressor IM
The following table lists the relevant compressor application parameters.
Pr.
00-11
Speed control mode
00-16
Load selection
00-17
Carrier frequency
Master frequency command source (AUTO)
00-20
/ Source selection of the PID target
00-21
Operation command source (AUTO)
00-22
Stop method
00-23
Control of motor direction
01-00
Maximum operation frequency
01-01
Output frequency of motor 1
01-02
Output voltage of motor 1
01-03
Mid-point frequency 1 of motor 1
01-04
Mid-point voltage 1 of motor 1
01-05
Mid-point frequency 2 of motor 1
01-06
Mid-point voltage 2 of motor 1
01-07
Minimum output frequency of motor 1
01-08
Minimum output voltage of motor 1
01-11
Output frequency lower limit
01-12
Acceleration time 1
01-13
Deceleration time 1
03-00
Analog input selection (AVI1)
03-01
Analog input selection (ACI)
05-01
Full-load current for induction motor 1(A)
0: Disabled
1: User-defined Parameter
2: Compressor IM
3: Fan
4: Pump
10: Air Handling Unit, AHU
Explanation
This parameter can be set during operation.
0: VF (IM V/F control)
0: Light load
Default setting
2: External analog input
1: External terminals.
0: Ramp to stop
1: Disable reverse
Default setting
Default setting
Default setting
Default setting
Default setting
Default setting
Default setting
Default setting
Default setting
20 (Hz)
20 (s)
20 (s)
0: No function
1: Frequency command
Default setting
12.1-13-1
Default: 0
Settings