Table of Contents
Advertisement
Meas Control
If in a measurement, accesses a menu of keys that allow you to abort,
pause, resume, or restart one of the measurements available in the
MEASURE
Press
Once the desired measurement is selected, press
Control
Aborts the current measurement. Pressing
Abort
is being made will stop the current measurement routine at the first
possible stopping point. Then the most recent measured values are
added to the signal list and the analyzer returns to the
pre-measurement state.
Key Access:
Allows you to pause a measurement. Pressing
Pause
measurement is being made will halt the current measurement routine
at the first possible stopping point. The analyzer will remain idle until
the measurement is aborted, resumed, or restarted.
Key Access:
Allows you to resume a measurement that had been paused. The key
Resume
label will toggle between
pause has been executed first. If an averaged measurement was in
progress when paused, the measurement continues and the average
counter resumes from its frozen value.
Key Access:
Performs the same functions as the
Restart
your measurement from the beginning. Pressing
measurement is being made will halt the current measurement routine
at the first possible stopping point and repeat the measurement.
Signals added to the signal list before the execution of the restart
routine will remain in the signal list. If auto measure is not currently
running, pressing this key has no affect.
Key Access:
Chapter 2
key menu.
and then select one of the available measurements.
MEASURE
accesses the following keys:
Meas Control
Meas Control
Pause
Meas Control
Meas Control
Meas Control
while a measurement
Abort
Pause
and
. Resume is active only if
Resume
"Restart"
front-panel key. Repeats
Restart
Front-Panel Key Reference
Meas Control
.
Meas
while a
while a
121
Advertisement
Table of Contents
