Table of Contents
Advertisement
Front-Panel Key Reference
AMPLITUDE Y Scale
Cable
Antenna, Cable, and Other correction factors are generally entered as
NOTE
positive values. This indicates a loss in the external device. User
correction factors are typically entered as negative values which
indicate a gain in the external device.
56
Delete Point
Allows you to delete the
amplitude-correction data for the
currently selected point. The prompt If
you are sure, press key again to
delete will appear on the display.
Pressing
the point and adjust all of the point
numbers as appropriate.
Key Access:
Corrections
Allows you to clear all data from the
Delete Correction
selected amplitude-correction set. The
prompt If you are sure, press key
again to delete will appear on the
display. Pressing
delete the correction set.
Key Access:
Corrections
Allows you to correct for cable loss, but may be used for
any kind of correction.
Key Access:
AMPLITUDE / Y Scale
Turns the amplitude correction
Correction On Off
function on or off for the selected set.
The corrections state must be set to On
for the correction to be applied.
Key Access:
Corrections
Accesses menu keys that allow you to
Edit
create and edit an amplitude-correction
factor set. It puts the analyzer into a
split-screen mode where the correction
data is displayed in a table under the
trace data. Pressing
menu will exit the menu and remove
the table from the screen. New points
will be applied only after the editor is
closed. The Tab keys are very useful for
again will delete
Delete Point
AMPLITUDE Y Scale
,
,
Antenna
Edit
again will
Delete
AMPLITUDE Y Scale
,
Antenna
,
,
More
Corrections
AMPLITUDE / Y Scale
,
Cable
while in this
ESC
,
More,
,
,
More
,
,
More
Chapter 2
Advertisement
Table of Contents
