Table of Contents
Advertisement
Delete all Corrections
Allows you to choose between the following menu selections.
MeasDetector
Key Access:
Peak
On Off
Quasi Peak
On Off
Average
On Off
Range Dwell
Chapter 2
Allows you to delete all amplitude-correction sets.
Key Access:
Meas Setup
,
.
Meas Setup
More
Allows you to turn peak measurements On or Off.
When Peak is On, you can change the measurement
dwell time. If this detector is On, the Measure at
Marker and the Auto-measure functions make a peak
detector measurement for the specified dwell time.
Default is On with a 200 ms dwell time.
Key Access:
Meas Setup
Allows you to turn quasi-peak measurement On or Off.
When
Quasi Peak
measurement dwell time. If this detector is On, the
Measure at Marker and the Auto-measure functions
make a quasi-peak detector measurement for the
specified dwell time. Default is On with a 200 ms dwell
time.
Key Access:
Meas Setup
Allows you to turn average measurement On or Off.
When Average is On, you can change the measurement
dwell time. If this detector is On, the Measure at
Marker and the Auto-measure functions make an
Average detector measurement for the specified dwell
time. Default is On with a 200 ms dwell time.
Key Access:
Meas Setup
Specifies the amount of time the analyzer dwells on a
signal during ranging. Ranging is the first step in a
signal measurement. During ranging, the analyzer
sweeps for the specified range dwell time, before
adjusting the signal peak to the top of the screen for
further measurements. If system defaults are restored,
Range Dwell will default to 200 ms. See "Dwell Time
Settings" in the Measurement Techniques" Chapter of
the Agilent EMC Analyzer EMC Measurement Guide
for more information.
Key Access:
Meas Setup
Front-Panel Key Reference
,
,
More
Corrections
,
,
More
Meas Detector
is On, you can change the
,
,
More
Meas Detector
,
,
More
Meas Detector
,
,
More
Meas Detector
Meas Setup
,
More
143
Advertisement
Table of Contents
