Agilent Technologies EMC Series User Manual page 210

Front-Panel Key Reference
Trace/View
Stores the amplitude data for the selected trace, and removes it from
Blank
the display. The selected trace register will not be updated as the
analyzer sweeps. This function is activated for traces 2 and 3 at
power-on and by pressing
Key Access:
Accesses the following
Operations
Key Access:
1↔2
2 − DL → 2
2 ↔ 3
1 → 3
2 → 3
Accesses the following
Normalize
Key Access:
Store Ref
(1→ 3)
Normalize
On Off
210
(when
Preset
Trace/View
Operations
,
Trace/View More
Exchanges the contents of the trace 1 register with the
trace 2 register and puts trace 1 and 2 in view mode.
Key Access:
Trace/View
Subtracts the display line from trace 2 and places the
result in trace 2 and puts trace 2 in view mode. The
2 − DL → 2
function is a math operation.
Key Access:
Trace/View
Exchanges the contents of trace 2 with trace 3 and puts
trace 2 and 3 in view mode.
Key Access:
Trace/View
Copies trace 1 into trace 3 and puts trace 3 in view
mode.
Key Access:
Trace/View
Copies trace 2 into trace 3 and puts trace 3 in view
mode.
Key Access:
Trace/View
Normalize
,
Trace/View More
Copies trace 1 into trace 3.
pressed before pressing
is pressed before
Store reference trace before turning on
Normalize is displayed in the status line, however
Normalize has been activated.
Key Access:
View/Trac
Activates the normalize function. On
Normalize (On)
each sweep, the normalized trace (Trace 3) is
subtracted from Trace 1 and the result is added to the
normalized reference level. The display shows the
result of the following calculation:
is set to
Preset Type
menu keys:
, ,
More Operations
, ,
More Operations
, ,
More Operations
, ,
More Operations
, ,
More Operations
menu keys:
Store Ref (1→ 3)
Normalize (On)
, the error message:
Store Ref (1→ 3)
, ,
More Normalize
.)
Factory
must be
. If
Normalize (On)
Chapter 2