Agilent Technologies EMC Series User Manual page 133

Apply Corrections
Yes No
Antenna
Antenna, Cable, and Other correction factors are generally entered as
NOTE
positive values. This indicates a loss in the external device. User
correction factors are typically entered as negative values which
indicate a gain in the external device.
Chapter 2
Pressing
Apply Corrections (Yes)
amplitude-correction factors. Corrections will only be
applied to the sets of correction factors whose correction
state is set to On. To turn a set of correction factors on,
use the
Correction On Off
Other, or User menus. When
selected, an A will appear on the screen annotation
whether or not a correction set has been turned on
using the
Correction (On)
Other, or User menus.
Key Access:
Meas Setup
Accesses the Antenna menu of keys which allow you to
correct for antenna loss, but may be used for any kind
of correction.
Key Access:
Meas Setup
Turns the amplitude correction
Correction On Off
function on or off for the selected set.
The corrections state must be set to On
for the correction to be applied.
Key Access:
Corrections
Accesses the antenna measurement
Antenna Units
units menu. You can choose
Gauss
measurement unit. Antenna Units is
active only when Antenna is chosen
from the Select list, otherwise it is
grayed out.
Key Access:
Corrections
Accesses menu keys that allow you to
Edit
create and edit an amplitude-correction
factor set. It puts the analyzer into a
split-screen mode where the correction
data is displayed in a table under the
trace data. Pressing
menu will exit the menu and remove
Front-Panel Key Reference
turns on the
key in the Antenna, Cable,
Apply Corrections (Yes)
key in the Antenna, Cable,
, ,
More Corrections
, ,
More Corrections
,
Meas Setup More
,
Antenna
µV/m µA/m
, , or
No Conversion
,
Meas Setup More
,
Antenna
while in this
ESC
Meas Setup
is
,
,
pTesla
as a
,
133