Agilent Technologies EMC Series User Manual page 135

For amplitude-correction factors, a maximum of two entries with the
NOTE
same frequency are valid. Only the first and last points of a series with
the same frequency values are used; any middle points are ignored.
Amplitude-correction data is sorted in the table by frequency. The
NOTE
sorting occurs immediately after you have entered the frequency value
via the front-panel.
Cable
Chapter 2
Amplitude
Allows you to enter the amplitude
value for the current
amplitude-correction point. After
selecting a point, the point number
automatically increments and
Frequency
of the frequency of the next point. Press
Bk Sp
Key Access:
Corrections
Delete Point
Allows you to delete the
amplitude-correction data for the
currently selected point. The prompt If
you are sure, press key again to
delete will appear on the display.
Pressing
the point and adjust all of the point
numbers as appropriate.
Key Access:
Corrections
Allows you to clear all data from the
Delete Correction
selected amplitude-correction set. The
prompt If you are sure, press key
again to delete will appear on the
display. Pressing
delete the correction set.
Key Access:
Corrections
Allows you to correct for cable loss, but may be used for
any kind of correction.
Key Access:
Meas Setup
Front-Panel Key Reference
becomes active to allow entry
to correct errors.
,
Meas Setup More,
, ,
Antenna Edit
again will delete
Delete Point
,
Meas Setup More,
, ,
Antenna Edit
again will
Delete
,
Meas Setup More
,
Antenna
, ,
More Corrections
Meas Setup
,
135