Agilent Technologies EMC Series User Manual page 142

Front-Panel Key Reference
Meas Setup
Amplitude-correction data is sorted in the table by frequency. The
NOTE
sorting occurs immediately after you have entered the frequency value
via the front-panel.
Freq Interp
Log Lin
142
Amplitude
Allows you to enter the amplitude
value for the current
amplitude-correction point. After
selecting a point, the point number
automatically increments and
Frequency
of the frequency of the next point. Press
Bk Sp
Key Access:
Corrections
Delete Point
Allows you to delete the
amplitude-correction data for the
currently selected point. The prompt If
you are sure, press key again to
delete will appear on the display.
Pressing
the point and adjust all of the point
numbers as appropriate.
Key Access:
Corrections
Allows you to clear all data from the
Delete Correction
selected amplitude-correction set. The
prompt If you are sure, press key
again to delete will appear on the
display. Pressing
delete the correction set.
Key Access:
Corrections
Allows you to determine how trace values are computed
between points in a correction table. If the linear mode
is selected, a straight line is used between points in a
correction table. If the logarithmic mode is selected,
frequency values between points are computed by first
taking the logarithm of both table values and the
intermediate value.
Key Access:
Meas Setup
becomes active to allow entry
to correct errors.
,
Meas Setup More,
, ,
User Edit
again will delete
Delete Point
,
Meas Setup More,
, ,
User Edit
again will
Delete
,
Meas Setup More
,
User
, , ,
More Corrections More
,
Chapter 2