Table of Contents
Advertisement
Front-Panel Key Reference
MEASURE
Accesses the Auto-measure menu. The auto measure function performs
Auto-measure
a measure at marker on all signals that meet the criteria (above the
margin or peak excursion) followed by an add to the list of all the
signals on the screen.
Key Access:
Start
Sigs > Margin
Peak
On Off
Quasi Peak
On Off
160
Key Access:
Signal Marking
,
.
MEASURE
More
Starts the Auto-measure process. Pressing this softkey
starts a series of routines which are designed to detect
the presence of signals and perform zero span
measurements on each one. As the measurement is
made, each signal is swept once (on the screen) to help
you keep track of the progress of the measurement. The
sweep that is shown is the last sweep before zooming to
zero span. If the signal list is turned On, you can see
each signal as it is added to the end of the signal list.
Key Access:
MEASURE
When On is selected, only the signals above the lowest
limit line margin on the screen are measured. If Off is
selected or no margin is on the screen then all the
signals on the screen that meet peak excursion are
measured. Default is Off.
Key Access:
MEASURE
Allows you to turn peak measurements On and Off.
When Peak is On, you can change the measurement
dwell time. If this detector is On, the Measure at
Marker and Auto-measure functions make a peak
detector measurement for the specified dwell time.
Default is On with a 200 ms dwell time.
Key Access:
MEASURE
Allows you to turn quasi-peak measurements On and
Off. When
Quasi Peak
measurement dwell time. If this detector is On, the
Measure at Marker and Auto-measure functions make
a quasi-peak detector measurement for the specified
dwell time. Default is On with a 200 ms dwell time.
Key Access:
MEASURE
,
,
MEASURE
More
,
Select Marks
,
,
More
Auto Measure
,
,
More
Auto Measure
,
,
More
Auto Measure
is On, you can change the
,
,
More
Auto Measure
,
Signal List
Chapter 2
Advertisement
Table of Contents
