Table of Contents
Advertisement
Front-Panel Key Reference
Display
Interpolation modes determine how limit values are computed between
NOTE
points in the limit table. The appearance of a limit trace is also affected
by the amplitude scale, which may be linear or logarithmic.
Selects whether limit lines will be entered using frequency or sweep
X Axis Units
time to define the segments. They can be specified as a table of limit
Freq Time
line segments of amplitude versus frequency, or of amplitude versus
time. Time values are evaluated with respect to the analyzer sweep
time. A time value of zero corresponds to the start of the sweep, which
is at the left edge of the graticule.
Switching the limit line definition between frequency and time will
erase both of the current limit lines. The message Changing X axis
units will delete all limits. If you are sure, press key
again to change units will appear. Press
to purge both limit lines and switch between frequency and time.
Key Access:
Allows you to choose fixed or relative limit lines. The fixed (
Limits Fixed Rel
uses the current limit line as a reference with fixed frequency and
amplitude values. The relative (
line value to be relative to the displayed center frequency and reference
level amplitude values. When limit lines are specified with time, rather
than frequency, the
current amplitude values will be relative to the displayed reference
level amplitude, but the time values will always start at the left edge of
the graticule.
88
logarithmic frequency space. An exactly
analogous manipulation is done for
logarithmic amplitude interpolation.
Key Access:
Limit 2
Amptd Interp
Allows you to determine how limit
Log Lin
trace values are computed between
points in a limit table. The available
interpolation modes are linear and
logarithmic. If the linear mode is used
for both frequency and amplitude, a
straight line is used when interpolating
between points in a limit table.
Key Access:
Limit 2
,
Display
Limits
Rel
setting only affects the amplitude values. The
Rel
,
Display
Limits
,
More
,
Display
Limits
,
More
X Axis Units Freq Time
) setting causes the current limit
,
or
Limit 1
,
or
Limit 1
again
) type
Fixed
Chapter 2
Advertisement
Table of Contents
