Table of Contents
Advertisement
Set Date
Accesses the following
Alignments
circuitry of the analyzer, load default values for the alignment system,
and adjust the 10 MHz reference.
Key Access:
Auto Align
It is normal to hear clicking sounds when the Auto Alignment function
NOTE
is On. During retrace, a small portion of the analyzer circuitry is
realigned. Some of the switching of the analyzer circuitry is done using
relays. It is the rapid switching of these relays during retrace that
causes the clicking sounds. To eliminate the clicking sounds, turn the
auto alignment off by pressing
When this is done, the
periodically. Refer to the appropriate "Specifications and
Characteristics" chapter in the Agilent Technologies EMC Analyzers
Specifications Guide for more information on how often to perform
Now
Chapter 2
Allows you to set the date of the real-time clock. Enter
the date in the YYYYMMDD format using the numeric
keypad and press
0000 through 9999. Valid month (MM) values are from
01 to 12, and valid day values are from 01 to 31.
Key Access:
Alignments
System
Accesses the
All
All but RF
Off
Align Now
,
when the auto alignment is off
All
. Valid year (YYYY) values are
Enter
,
System
Time/Date
menu keys which align the internal
menu keys.
Auto Align
Turns on the automatic alignment of all
measurement systems. When
,
is selected, "
Align
All
the left edge of the display.
Key Access:
System
Turns on the automatic alignment of all
measurement systems except the RF
section. (Eliminating automatic
alignment of the RF prevents changes
in the input impedance between
sweeps, which could cause input device
instability.) When
is selected, "
" appears along the left
AB
edge of the display.
Key Access:
System
Turns off automatic alignment.
Key Access:
System
,
System
Alignments
,
function should be performed
All
Front-Panel Key Reference
System (Local)
Auto
" appears along
AA
,
Alignments
,
Auto Align
All but RF
,
Alignments
,
Alignments
,
,
.
Auto Align
Off
Align
197
Advertisement
Table of Contents
