Agilent Technologies EMC Series User Manual page 63

Delete Correction
Freq Interp
Allows you to determine how trace values are computed
Log Lin
between points in a correction table. If the linear mode
is selected, a straight line is used between points in a
correction table. If the logarithmic mode is selected,
frequency values between points are computed by first
taking the logarithm of both table values and the
intermediate value.
Key Access:
Delete all Corrections
Key Access:
Chapter 2
Amplitude
Allows you to enter the amplitude
value for the current
amplitude-correction point. After
selecting a point, the point number
automatically increments and
Frequency
of the frequency of the next point. Press
to correct errors.
Bk Sp
Key Access:
Corrections
Delete Point
Allows you to delete the
amplitude-correction data for the
currently selected point. The prompt If
you are sure, press key again to
delete will appear on the display.
Pressing
Delete Point
the point and adjust all of the point
numbers as appropriate.
Key Access:
Corrections
Allows you to clear all data from the
selected amplitude-correction set. The
prompt If you are sure, press key
again to delete will appear on the
display. Pressing
delete the correction set.
Key Access:
Corrections
AMPLITUDE Y Scale
Allows you to delete all amplitude-correction sets.
AMPLITUDE Y Scale
Front-Panel Key Reference
AMPLITUDE Y Scale
becomes active to allow entry
AMPLITUDE Y Scale
, ,
User Edit
again will delete
AMPLITUDE Y Scale
, ,
User Edit
again will
Delete
AMPLITUDE Y Scale
,
User
, ,
More Corrections
, ,
More Corrections
,
More,
,
More,
, ,
More
,
More
,
More
63