Calibration Data - Micromeritics AccuPyc 1330 Operator's Manual

Editing the Setup Parameters

Calibration Data

Press
When the pycnometer is calibrated, cell volume and expansion volume
are updated automatically.
4-24
2 to display or edit calibration data.
Display
Set up type?
Calibration data
Cell volume:
(value from calibration)
Expansion volume:
(value from calibration)
Temperature offset:
(pre-set value)
Entry
Press until Calibration data is
CHOICE
displayed. Then press
Enter the cell volume and press
Range: 0.01 to 999.0000 cm
Enter the expansion volume and press
.
ENTER
Range: 0.5 to 999.0000 cm
The temperature offset is pre-set at the
factory and is entered on the Calibration
Sheet shipped with the instrument. It should
not be changed unless the battery-backed
RAM is reinitialized.
If battery-backed RAM is reinitialized, enter
the value from the calibration sheet and
press .
ENTER
Range: 0 to 100.00°C
AccuPyc 1330
.
ENTER
.
ENTER
3
3
September 1996