Table of Contents
Advertisement
APPENDIX A
4.
Disconnect the gas supply line from the rear panel of the pycnometer by
turning the nut on the INLET connector counterclockwise with a 7/16 in.
open-end wrench (refer to Figure A-1).
5.
Disconnect the gas vent line (if attached) by gently pulling the flexible tub-
ing from the rigid tubing labeled VENT at the rear of the pycnometer.
6.
Remove the printer cable and the serial cable (if used) from the rear panel
of the pycnometer.
7.
Remove the cap from the cell chamber.
A-2
FILL
EXPAND
7
8
ANALYZE
REVIEW
5
4
MANUAL
SETUP
1
2
CALIBRATE
ZERO
•
0
Figure A-2. Pycnometer Keypad
AccuPyc 1330
VENT
9
PRINT
6
SAVE
TRANSMIT
ESCAPE
3
CLEAR
CHOICE
ENTER
September 1996
Advertisement
Table of Contents
Need help?
Do you have a question about the AccuPyc 1330 and is the answer not in the manual?
Questions and answers