Table of Contents
Advertisement
Error and Status Messages
Messages Displayed During an Automatic Operation
When an automatic operation is in progress, status messages are continually
displayed.
Automatic operation
has been canceled
Print in progress
[ESCAPE] to cancel
Printer port
not responding
Sending line (line number)
[ESCAPE] to cancel
Transmission port
not responding
5-12
Cause:
The automatic operation has been canceled by the user.
Action:
Wait for the termination process to complete or end the
termination process by pressing
more times.
Cause:
Status message displayed when a report is being printed.
Action:
None; this is a status message only.
Cause:
The printer took longer than 30 seconds to acknowledge
receipt of data from the pycnometer.
Action:
Check to make sure the printer is properly connected to
the pycnometer, is turned on, and is on line.
Cause:
Status message displayed when data are being transmitted.
Action:
None; this is a status message only.
Cause:
The receiving device took longer than five seconds to ac-
knowledge receipt of data from the pycnometer.
Action:
Make sure the receiving device is properly connected to
the pycnometer RS-232 port and is turned on. Verify that
the serial I/O parameters controlling the receiving device
correspond with the data transmission parameters in the
set up mode.
AccuPyc 1330
two
CLEAR
March 2001
Advertisement
Table of Contents
Need help?
Do you have a question about the AccuPyc 1330 and is the answer not in the manual?