Selecting Units Of Pressure Measurement And Operating Language - Micromeritics AccuPyc 1330 Operator's Manual

AccuPyc 1330
Selecting Units of Pressure Measurement
and Operating Language
The units of measurement for pressure may be displayed in pounds-per-
square-inch gauge (psig) or kilopascal gauge (kPag). In this manual, psig is
used in the examples shown. The pycnometer may be operated in any of five
languages: English, French, German, Italian, or Spanish. The default for units
is psig and the default language is English. If you wish to use these defaults,
no further action is necessary; proceed to Greasing the Chamber Cap
O-Ring. If you wish to change the defaults:
1.
2.
3.
If there are error messages in the message queue (indicated by an aster-
isk next to the Reload prompt), delete the messages before changing lan-
guages. Refer to Error, Report, and System Status Messages, Chapter 4.
Make sure you press
4.
September 1996
Press , then press
2
Press ENTER .
Press then
CHOICE ENTER
The Language prompt is displayed. Press
guage is displayed, then press
SAVE
Place the appropriate template (included in the accessory kit) over the
pycnometer keypad.
until Unit types is displayed.
CHOICE
to change the value to kPag.
CHOICE
.
SAVE
after changing languages.
Equipment Setup
until the desired lan-
2-9