Unit Types, Operating Language, Date, And Time - Micromeritics AccuPyc 1330 Operator's Manual

AccuPyc 1330

Unit Types, Operating Language, Date, and Time

Press
or time.
If there are error messages in the message queue (indicated by an aster-
isk next to the Reload prompt, delete the messages before changing lan-
guages. Refer to Error, Report, and System Status Messages in Chapter
4. Make sure you press SAVE after changing languages.
September 1996
2 to display or edit unit types, operating language, date,
Display
Set up type?
Unit types
Pressure Units?
psig
Language?
English
Date (DD/MM/YY)
(pre-set date)
Editing the Setup Parameters
Entry
Press until Unit types is displayed.
CHOICE
Then press .
ENTER
Select either psig (pounds-per-square-inch
gauge) or kPag (kilopascal gauge), then
press .
ENTER
Select the desired language, then press
.
ENTER
Choices:English, Deutsch, Español,
Francais, or Italiano
The date is included in all printed and
transmitted reports. If the date shown is
incorrect, you may enter the correct date as
follows: day/month/year. Note that each
entry must contain two digits.
For example, to enter September 1, 1992,
enter 01/09/92 and press
•
The key is used to enter a slash (/).
.
ENTER
4-27