Entering Report And Analysis Parameters - Micromeritics AccuPyc 1330 Operator's Manual

Equipment Setup

Entering Report and Analysis Parameters

The pycnometer is shipped with the following default values for analysis pa-
rameters:
If you wish to use these values, no further action is necessary. If you wish
to change the values, refer to Analysis or Calibration Parameters in
Chapter 4.
The pycnometer is shipped with the following default values for report op-
tions:
If you wish to use these values, no further action is necessary. If you wish to
change the values, refer to Report Options in Chapter 4.
2-8
Number of purges
Purge fill pressure
Number of runs
Run fill pressure
Equilibration rate
Run precision
Percent full scale
Request sample ID
Analysis display mode
Report destination
Transmission format
AccuPyc 1330
3
19.5 psig
3
19.5 psig
0.005 psig/min
No
0.05
no
volume
display
Single column
September 1996