Micromeritics AccuPyc 1330 Operator's Manual page 31

AccuPyc 1330
4.
Viewing or Printing Analysis Results
1.
2.
3.
4.
5.
September 1996
The following prompt is displayed.
[Enter] to start
Press to begin the analysis.
ENTER
As the analysis is performed, operational status messages are displayed.
(Refer to Monitoring the System in Chapter 4 for a description of the
messages.)
When the analysis is complete, the pycnometer beeps three times. Re-
move the sample from the cell chamber. Press
the error messages.
After the error messages are displayed, the average volume or density
and the deviation from the mean are displayed. Press
A report is automatically printed if report destination was set to printer.
If not, you may print a report by pressing
transmit a report by pressing
3 .
When the Reload prompt is displayed, you may begin another operation.
Starting an Analysis
to cycle through
CHOICE
.
ENTER
6 . You may
3-5