Micromeritics AccuPyc 1330 Operator's Manual page 60

Editing the Setup Parameters
4-28
Display
Time (HH:MM:SS)
(pre-set time)
Set up type?
Unit types
Entry
The time (in 24-hour format) at which an
analysis was started and completed is
shown on all printed and transmitted
reports. If the time shown is incorrect, you
may enter the correct time as follows:
hours/minutes/seconds. Note that each
entry must contain two digits.
For example, to enter 1:05 P.M., enter
13:05:00 and press
ENTER
•
The key is used to enter a colon (:).
Choose one of the following options:
Press to save the information you
SAVE
entered and return to display mode.
Enter another set-up type.
Press
CLEAR
information you entered and return to
display mode.
AccuPyc 1330
.
to discard the
September 1996