Multi-Sheet Bypass Feeder Components; Multi-Sheet Bypass Feeder; Drive Gear; Multi-Sheet Bypass Feeder Sensors - Xerox 2135N - Phaser Color Laser Printer Quick Reference Manual

Multi-sheet bypass feeder components

Multi-sheet bypass feeder

Warning Switch off the power and disconnect the power cord.
1. Open the top cover. Remove the drum/toner cartridges. Place them in
a lightproof black bag to protect the drum units from light and store in a
safe place.
2. Open the front cover.
3.
Remove the left-side cover as described in the topic "Left-side cover" on
page 91.
4.
Remove the rear shield plate"Rear shield plate" on page 97.
5. Remove the upper and lower EMI suppressors on the print engine
controller harnesses. (Use a small screwdriver to release the latch on
each suppressor). Cut cable ties as necessary.
6.
Disconnect the wiring harnesses REG and COVOPN from the print
engine controller board.
7. Remove the four black screws securing the multi-sheet bypass feeder
top cover. Remove the cover.
8. Open the multi-sheet bypass feeder tray.
9.
Remove the two black screws securing the multi-sheet bypass feeder to
the printer.
10.
Lift and remove the multi-sheet bypass feeder.
Note
If replacing the multi-sheet bypass feeder drive gear, continue
with Step 12.

Drive gear

1.
Remove the ground strap at the end of the drive gears shaft, it is held in
place by one screw.
2.
If replacing the drive gear, release the two locking tabs on the inside of
the drive gear and remove the gear from the shaft.

Multi-sheet bypass feeder sensors

Disconnect the sensor's wiring harness from the multi-sheet bypass feeder
entrance sensor or the transparency sensor and unclip the sensor from the
multi-sheet bypass feeder.

Temperature/humidity sensor board

Disconnect the board's wiring harness from the board. Remove the screw
securing the board in place.
Service Guide 119