4.4
Removing server nodes from the server
enclosure
The server enclosure must always run with closed node bays. It is only
allowed to leave a bay open for a limited time in case of repairing a
server node (for example). In the meantime all remaining server nodes
run in throttling mode (with reduced performance).
Removing the CX2550 M6 or CX2560 M6 server node
CAUTION
▶
Follow the safety instructions in
▶ Shut down the server node and disconnect all external cables.
Figure 3: Removing the CX2550 M6 or CX2560 M6 server node (A)
▶ Unlock the lever tip (1).
CX400 M6
Upgrade and Maintenance Manual
Basic hardware procedures
"Important information" on page
25.
43