Table of Contents
Advertisement
Figure 58: Pushing the server node into the server enclosure (B)
▶ Ensure that the locking mechanism of the lever tip snaps into place (see
circle).
▶ If applicable, connect all external cables to the server node.
▶ When you add the server node to the server enclosure, perform the
following steps:
▶ Pull out the ID card from the server enclosure, see
front" on page
▶ Stick the label that describes the product name and the serial number of
the server node on the ID card.
The label that describes the product name and serial number is
included in the delivery pack of the server node.
Before sticking the label, write the server node bay number of the
server node location on the label.
If you don't stick the label on the ID card, you may not be able to
receive the maintenance service.
▶ Push the ID card into the server enclosure.
CX400 M6
195.
Upgrade and Maintenance Manual
Basic hardware procedures
"Server enclosure
83
Advertisement
Table of Contents
