High speed riser module
Figure 117: Fastening the high speed riser module
▶ Fasten the corresponding high speed riser module with two screws (see
circles).
Concluding steps
▶
"Installing the top covers" on page
▶
"Sliding the server enclosure into the rack" on page
▶ If applicable, install the front bezel, see
page
47.
▶ If applicable, install the server nodes in the server enclosure, see
server nodes in the server enclosure" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server nodes" on page
154
56.
"Installing the front bezel" on
84.
Upgrade and Maintenance Manual
68.
81.
86.
"Installing
CX400 M6