Table of Contents
Advertisement
▶ Pull the HDD/SSD module completely out of its bay.
Installing a 2.5-inch dummy module
CAUTION
▶
If the removed HDD/SSD module is not replaced immediately,
always replace a dummy module into the unused HDD/SSD bay to
comply with applicable EMC regulations and satisfy cooling
requirements.
Figure 81: Installing the 2.5-inch dummy module
▶ Push the dummy module into the empty bay until it engages.
Concluding steps
▶ If applicable, install the front bezel, see
page
47.
CX400 M6
Hard disk drive (HDD) / solid state disk (SSD)
"Installing the front bezel" on
Upgrade and Maintenance Manual
117
Advertisement
Table of Contents
