Removing The Server Node Dummy Module - Fujitsu PRIMERGY CX400 M4 Upgrade And Maintenance Manual

4.6

Removing the server node dummy module

I
The CX400 M4 system must always run with closed node bays. It is only
allowed to leave a bay open for a limited time in case of repairing a server
node (for example). In the meantime all remaining server nodes run in
throttling mode (with reduced performance).
V
CAUTION!
Follow the safety instructions in the chapter
●
on page
Figure 9: Removing the server node dummy module
Ê Undo the locking mechanism (1) of the release lever and pull the server
node dummy module out of the slot (2).
CX400 M4
25.
Upgrade and Maintenance Manual
Basic hardware procedures
"Important information"
49