Racelogic VBOX Touch V2 User Manual page 56

How to Manually Set a Start/Finish Line
It is possible to manually set a start/finish line when
moving, overwriting the line detected within the circuit
layout.
To manually set a start/finish line, tap the screen within
the Basic Lap Timing Screen or select Set Start Gate
within the Settings.
A screen will be displayed, allowing you to cancel the
start/finish line gate set within 5 seconds by repressing
the screen. After 5 seconds, you are required to drive
forward in a straight direction to complete the process.
The gate is set at 90° to the detected heading and the
width is dependent in what is selected within the Gate
Width Settings.
The detected location when the screen is initially
pressed/start gate set is used as the centre point of
start/finish gate.
If you are defining a separate Finish Line, this gate will
act as the Start Line only.
Notes:
• The vehicle must be moving >0.8 km/h and the unit have satellite lock to set a Start/Finish Line.
• If start/finish line setting is cancelled, any live lap prediction for the current lap will be lost and unavailable for use.
User_Guide_%E2%80%93_VBOX_Touch_V2/05_Display_Modes_%E2%80%93_VBOX_Touch_V2/VBOX_Touch_V2_-
https://en.racelogic.support//Product_Info/VBOX_Data_Loggers/VBOX_Touch/VBOX_Touch_V2/
New start/finish line cancellation screen
_Lap_Timing_Mode
56