YASKAWA BACnet/IP JOHB-SMP3 Technical Manual page 16

5 Installation Procedure
3.
Use the two screws included in the option kit to fasten the option card to the metal standoffs on the bypass
PCB. Use a short-shaft, magnetic screwdriver for narrow enclosure models H6BPxxxx. Tighten each
screw to 0.5 to 0.6 N•m (4.4 to 5.3 in lbs).
4.
Firmly insert the end of the customer-supplied network cable into the CN1 connection port on the option
board. When you have a dual-port option, connect two network cables to the two network ports in CN1 for
flexibility in cabling topology.
NOTICE
interference can cause communication data errors.
5.
Make sure that you did not pinch cables between the front cover and the bypass enclosure, then replace
and secure the front cover.
6.
Set drive parameters in
16
CN5
Figure 5.6 Insert Option into Bypass PCB CN5 Connector Port
Figure 5.7 Connect Network Cable to Option
Separate the communication wiring from the input power wiring and the motor wiring. Electrical
Related Drive Parameters on page 18 for correct option performance.
YASKAWA SIEP C730600 0MA BACnet/IP Technical Manual