Kyocera KM-8030 Advanced Operation Manual page 76

Copying Functions
Reducing/Enlarging
Select the desired magnification as follows.
1
On the [Basic] screen, press
[Reduce/Enlarge].
2 Select the desired magnification.
For instructions on reducing/enlarging,
refer to Reducing/Enlarging in Chapter 3
of the Operation Guide for details.
3 Press [Close].
Original Orientation
Specify the original orientation as follows.
1 On the [Basic] screen, press [Orig. Set
Direction].
2
Based on the original orientation, press
[Top Edge] ([Back Edge]) or [Left Top
Edge] ([Left top corner]).
NOTE: Failure to place originals
correctly may result in copying errors.
3 Press [Close].
1-70
Ready to Job build.
Place originals then press Start key.
Job Build Step
1 sided
11x8½"
Select Original
Paper Type
Auto %
Reduce
Finished
/Enlarge
Basic
Quality
Ready to Job build.
Place originals then press Start key.
Reduce/Enlarge
Standard
Zoom
XY Zoom
# keys
Ready to Job build.
Place originals then press Start key.
Job Build Step
1 sided
11x8½"
Select Original
Paper Type
Auto %
Reduce
Finished
/Enlarge
Basic
Quality
to Job build.
nals then press Start key.
tion
"Select Original Image Direction." can
be shown at right side of display.
Follow the steps. If setting mode is
wrong, incorrect copy will result.
2 sided Copy
1 sided/
2 sided
1 sided copy-Left
Rear
Finished page #:
Orig. Set
Direction
Edit
Back
154%
Auto %
5½x8½" 8½x14"
129%
100%
8½x11" 11x17"
400% 121%
8½x14" 11x17"
200% 78%
5½x8½" 11x17" 8½x14" 8½x11"
2 sided Copy
1 sided/
2 sided
1 sided copy-Left
Rear
Finished page #:
Orig. Set
Direction
Edit
Set
Back Close
Select Original Image
Direction.
Left Top
Top Edge
Edge
77%
11x
64%
11x
50%
11x
25%